Medium Voltage Fill Shield Power Cable

Medium Voltage Fill Shield Power Cable

Conductor

Solid or Class B compressed concentric lay stranded 1350 aluminum meeting the requirements of ANSI/ICEA S-97-682.

Conductor Shield: Extruded semi-conducting thermosetting polymeric stress control layer.

Insulation

 Extruded Ethylene Propylene Rubber (EPR) Class II and III as defined in ANSI/ICEA S-97-682.

Insulation Shield

Extruded semi-conducting thermosetting layer, clean and free stripping from insulation.

Copper Wire Shield: Helically applied annealed solid bare copper wires with a lapped non-metallic tape serving as a binder/separator.

Jacket: Black, non-conducting, sunlight-resistant (PVC) or LLDPE.

► Triple-extruded for clean interfaces 

► Flexibility for easy handling 

► Excellent moisture resistance 

► Deformation-resistant 

► Sunlight-resistant

► High dielectric strength 

► Low dielectric loss 

► Excellent resistance to water treeing 

► Clean-stripping insulation shield without the use of a release agent 

► Standard: ANSI/ ICEA S-97-682 and AEIC CS8

Medium Voltage Fill Shield Power Cables are intended for use in dry or wet locations for distribution of three-phase medium-voltage power. Because it's filled with shield, these medium voltage cables may be installed in ducts or direct buried. 


LEAVE A MESSAGE

Now leave a message to get the maximum discount, we will contact you within 24 hours, and will strictly keep your information confidential. Please fill it out safely.